Description
The Easy Hydro Rainwater Harvesting Systems
The easy hydro systems are designed for an easier installation and easy to work system.
Easy Hydro System
Simplicity is the key to this system. Designed with the DIY enthusiast in mind, our step-by-step guidelines will have this system up and running as quickly as you can work.
The tank is UK manufactured and made of high quality MDPE in a one piece seamless mould to ensure longevity and strength. The amphibious pump is also UK manufactured and comes with a two year RTB warranty for your peace of mind
Never worry about a hosepipe ban again. The Easy Hydro system is an absolute must to help you keep your garden the envy of your neighbours.
How The Easy Hydro System Works
Connect your rainwater downpipe to the Ecosure underground water filter via underground pipework.Using the other 4" outlet on the underground water filter, connect this to your Ecosure underground water tank using one of the pre-moulded 4" outlets in the tank (this will need to be drilled out).Drill a hole near the top of water tank and feed the rainwater pipe into the tank.Before lowering your water pump into the water tank you should connect the rainwater pipe to the water pump.Run the rainwater pipe to where want to put your garden tap.Easy HYDRO System Includes 3500 Rainwater harvesting tank35m head submersible water pump25m of rainwater harvesting pipePump connectorsGarden tap and connectionsRoll of PTFE TapeBackup in a boxRainwater Harvesting Tank DimensionsHeight 1225mm
Diameter 2150mm
Outlet Upto 4" Outlet
Weight 145kg
Capacity 3500 litres
Rainwater Pump SpecificationsThe HydroForce Series 3 is an electronically-controlled, pressure-sensitive, submersible, centrifugal roto-dynamic pump with no reciprocating parts.
- Pressure-sensitive (demand) pump which turns itself off until there is a demand for water.
- Max head (nominal) 35 metres, pump pressure at outlet 3.5 bar.
- Dry-run Protection: when no water is detected for 8 seconds, the pump is turned off by the printed circuit board (PCB) in order to protect the motor and pump from burning out. Automatic reset after a period of 30 minutes. If water is still not detected, subsequent reset periods are 1.5 hours, 3 hours, 7 hours, 12 hours, 24 hours then back to the beginning of the cycle. Additionally, a thermal switch, not connected to the PCB, turns the pump off when motor overheats. It resets when cool which make take several hours.
- New: Inlet cartridge filter, inlet strainer and output pipe connector are factory-fitted and the seals tested to ensure proper running of the pump.
Guaranteed for 2 years.
- Electricity consumption 800 watts at 220-240 Volts AC 50 Hz (requires 10 or 13 amp fuse and RCD mains socket). Connection cable 10m H07RN-F.
- Inlet port to the non-removable filter 1 inch (25mm) female BSP. Output port 1 inch (25mm) female BSP provided with push-fit connector for 1 inch (25mm) MDPE pipe (1 ¼ inch (32mm) connector option by special order).
- Dimensions L 565 W 185 H 260 mm, weight 13.1 kgs
Dimensions
Easy Hydro Rainwater Harvesting Tank 3500 Litres
| Dimensions | H:1675mm x Dia:2150mm |
| Outlet | Upto 4" |
| Access | 160kg |
| Weight | 16" Lid |
| Capacity | 5000 litres / 1100 gal |
